08-09-2010 06:59 AM - edited 03-10-2019 05:18 PM
My setup has cisco WLC 5508 & ACS 1120 ver 5.0. How do i authenticate users who access the WLC via the ACS 1120 that users TACACS+. I am able to authenticate users for cisco routers and switches, but when I try to same for WCL, it fails.
Can someone please explain the basic config/steps that needs to be configured on both WLC & ACS.
Solved! Go to Solution.
08-09-2010 12:09 PM
Are you using plain vanilla 5.0 or have any patches installed?
ACS 5.1 has new TACACS related functionaity including support for custom services and attributes. If these are needed for WLC support yo would need ti upgrade.
There may also have been relevant patch fixes since 5.0 timeframe but I can't find any specific relevant CDETS at this point
08-09-2010 12:09 PM
Are you using plain vanilla 5.0 or have any patches installed?
ACS 5.1 has new TACACS related functionaity including support for custom services and attributes. If these are needed for WLC support yo would need ti upgrade.
There may also have been relevant patch fixes since 5.0 timeframe but I can't find any specific relevant CDETS at this point
08-09-2010 10:50 PM
thanks jrabinow... yes i am using plain vanilla 5.0 ... i will try with 5.1 version... i will get back to u...
Thanks again... u have being very helpful...
08-11-2010 12:36 AM
hi jrabinow, i updated the ACS from 5.0 to 5.1 and everything is working perfect !!!!! Thankyou.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: