×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
chrhiggi Mon, 08/09/2010 - 15:52
User Badges:
  • Silver, 250 points or more

Hello Jaime-


The GSS has a "shutdown" command at the enable prompt.

For the ACE 4710 - you can hold down the power button on the front, there is no cli command.

For the ACE10-mod-k9 and ACE20-mod-k9, you can issue "no power enable module X"


On a side note, there is a "shutdown" button on the front of the ACE modules that you can use a paperclip to access. However, functionality of this button is actually to reset the module, not power it off.


cat-1#sh module
Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
  1    6  Firewall Module                        WS-SVC-FWM-1       SAD084305R8
  2    1  Application Control Engine Module      ACE10-6500-K9      SAD094701MY
  3    1  Application Control Engine Module      ACE20-MOD-K9       SAD1141053B
  5    2  Supervisor Engine 720 (Active)         WS-SUP720-3BXL     SAD081200ES
  6   48  48-port 10/100 mb RJ45                 WS-X6148-RJ45V     SAL0651ADR6
  9    3  AON Module                             WS-SVC-AON-1-K9    SAD08320722


cat-1(config)#no power enable module ?
  <1-9>  module slot number



cat-1(config)#no power enable module 3

%Power admin state updated


Regards,

Chris Higgins

Actions

This Discussion