I have a cisco 1941w with ios c1900-universalk9-mz.SPA.150-1.M2.bin and I am using Cisco CP Express GUI. It tells me that the firewall feature set in unavailable. The IOS image in your router does not support the requested feature.
How do I get CP Express to configure the firewall feature?
Yup. That was I.
Your ip nat outside is on the wrong interface. It should be on G0/1, not G0/0.
no ip nat outside
no ip nat inside
ip nat outside
I wish it was a Cisco switch. HP does things different what they call a trunk is actually an ether-channel of ports.
Not really. So in the switch, make sure the trunk port is configure to 802.1q and allow all VLAN's to go through. That is about it.
If it is a Cisco switch the configuration looks like the follow
switchport trunk encapsulation dot1q
switchport mode trunk
The switch is an HP Procurve switch. Do you still want the switch config?
Please post your switch configuration also. The router configuration looks okay.
Contact Cisco Licensing ([email protected]) and they will send you the license file to install on the device
You need to purchase the license from a Cisco reseller. The link below
lists the different license options and the part numbers.
Is that something I need to purchase or is it a download feature set license?
Like I mentioned earlier, you need a Security license. You currently have only a IP Base license
In the command prompt (via console, telnet or ssh) do show license all and post the output here.
You need to have the Security license for the firewall features. You can check what license you have with a show version/show license