Hello, we are trying to configure a pair of Nexus 5K's and setup vpc peer link between them. When I issue the show vpc brief command, the peer-keepalive link is working fine, but the vpc peer relationship isn't coming active. I'm following the Cisco N5K config guide and have both sides of the 5K's config'd the same (except for the peer keepalive IP addresses) but can't seem to bring the vpc peer link active. Are there any vpc setup guides that anybody has found helpful? Thanks in advance for any suggestions, John
i think that vlan 1 should be allowed on trunk on both portchannels , not sure if it must be native.
Also the ip put for keep alive on interface mgmt0.