Dial plans and peers in CUCM 7

Unanswered Question
Aug 11th, 2010
User Badges:

dear any body


can you please tell me that how i can configure dial peers that i should call from one voip to another voip system in CUCM7 becouse in CME in routers the configuration was simple so can any body tell me how i can do this in call manager 7 please its need for me to learn this asap and to implement this in my office.


the CME configs was like this


dial-peer voice 1 pots
 destination-pattern 555....
 port 1/0:1

dial-peer voice 2 voip
 destination-pattern 555....
 session target ipv4:192.168.1.1

but i dont know in cisco call manager 7 can any body help me pleaseeeeeee


with regards

http://www.ciscosystems.com/en/US/i/000001-100000/35001-40000/36501-37000/36849.jpg

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jonathan Schulenberg Thu, 08/12/2010 - 03:46
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

You will need to create a SIP or H.323 trunk to the other system. Once that is configured you can add a route pattern and select the trunk as the off-net path to take. The route pattern will need to be in a partition that is included in the CSS of the calling party.


CME and UCM are two totally different platforms. Very little of what you understand about CME holds true in UCM and vice versa.

Waisudin Farzam Fri, 08/13/2010 - 21:55
User Badges:

dear Jonathan


thx for your reply but in this case do i need a Gateway or gatekeeper in between to do this task or cucm 7 can do this job

if i need can you send me a note of step by step

regards

Actions

This Discussion