LMS 3 SNMP authentication using different communities

Answered Question
Aug 12th, 2010
User Badges:

Hello,


Is it possible to use different community strings for the SNMP set/polling and traps in Ciscoworks.

Can't find this in the documentation or the web.


So the config on the network device would look something like this:


! SNMP communities

!
snmp-server community SNMPREAD RO    ! Read-Only community
snmp-server community SNMPWRITE RW    ! Read-Write communicy
!
! SNMP traps
!
snmp-server host 1.1.1.1 version 2c SNMPTRAPS                   ! SNMP trap


In LMS I can only find to configure the port timeout and read/write community of a device.


Thanks for the assistance in advance

Correct Answer by Joe Clarke about 6 years 7 months ago

LMS doesn't care about the trap community string (you can configure whatever value you want on the device).  However, you can certainly configure different read-only and read-write strings.  This is done under Common Services > Device and Credentials > Device Management.  Click the Edit Credentials button, then fill in the appropriate values for each string.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Sat, 08/14/2010 - 12:40
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

LMS doesn't care about the trap community string (you can configure whatever value you want on the device).  However, you can certainly configure different read-only and read-write strings.  This is done under Common Services > Device and Credentials > Device Management.  Click the Edit Credentials button, then fill in the appropriate values for each string.

orsonjoon Sun, 08/15/2010 - 22:44
User Badges:

Allright Joe just what I needed to kno

w, many thanks again....

Actions

This Discussion