08-12-2010 02:56 AM
Hello,
Is it possible to use different community strings for the SNMP set/polling and traps in Ciscoworks.
Can't find this in the documentation or the web.
So the config on the network device would look something like this:
! SNMP communities
!
snmp-server community SNMPREAD RO ! Read-Only community
snmp-server community SNMPWRITE RW ! Read-Write communicy
!
! SNMP traps
!
snmp-server host 1.1.1.1 version 2c SNMPTRAPS ! SNMP trap
In LMS I can only find to configure the port timeout and read/write community of a device.
Thanks for the assistance in advance
Solved! Go to Solution.
08-14-2010 12:40 PM
LMS doesn't care about the trap community string (you can configure whatever value you want on the device). However, you can certainly configure different read-only and read-write strings. This is done under Common Services > Device and Credentials > Device Management. Click the Edit Credentials button, then fill in the appropriate values for each string.
08-14-2010 12:40 PM
LMS doesn't care about the trap community string (you can configure whatever value you want on the device). However, you can certainly configure different read-only and read-write strings. This is done under Common Services > Device and Credentials > Device Management. Click the Edit Credentials button, then fill in the appropriate values for each string.
08-15-2010 10:44 PM
Allright Joe just what I needed to kno
w, many thanks again....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide