cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
553
Views
0
Helpful
3
Replies

Setting up 1751V router

mudassar.khan
Level 1
Level 1

Hi All,

I am in the initial phase of setting up a 1751V with 2 port FXO and 2 port FXS card to use with Cisco CME. Router has got 32M Flash and 256K PVDM. Please find the attached output of "show version" and "show INV" for your analysis.

The issues is that router is not detecting both FXO and FXS cards at the same time and one voice card ends up with the amber lights lit after booting up the router. It only picks up one card at a time whoever is installed in the lowest slot of the router and the other can't be seen in "sh voice port summary".

Any suggessions please?

Regards,

Muds

3 Replies 3

Matthew Kaufman
Cisco Employee
Cisco Employee

How many DSP's do you have installed? By default with High Codec complexity, one dsp module will only support 2 analog voice ports, so check the number of DSP's.

--Matt

paolo bevilacqua
Hall of Fame
Hall of Fame

Already posted (and answered§) in another area, please do not post duplicates.

mudassar.khan
Level 1
Level 1

https://learningnetwork.cisco.com/message/82290#82290

You will find it on the above link.

regards,

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: