How-to:Configure IP, Gateway, Loopback, etc. for CUE for restore

Unanswered Question
Aug 12th, 2010

What commands are required to configure CUE IP address, loopback interface, gateway, etc. before doing a factory reset. My IP address has not been set for the CUE so I can't issue the standard factory restore commands without getting an error.

These would be issued prior to

service-module integrated-Service-Engine 0/0 session

Thank you.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion