Don't know how to setup a simple VLAN on the RVS4000

Unanswered Question
Aug 12th, 2010
I'm sure it is my lack of knowledge of networks, but even after reading the manual (!) I don't understand how I can set-up a simple VLAN on my new RVS4000.

On my good old DrayTek it's very easy: it shows me a matrix of check boxes and all I have to do is click the ones that correspond to ports that can 'see' eachother. Something like this:

               Port 1   Port 2   Port 3   Port 4

VLAN 1    x                          x

VLAN 2                      x        x

VLAN 3             x                 x

VLAN 4

So port 1-3 can all 'see' port 4 (the Internet router) but they can't 'see' eachother.

Can anyone please show me the steps to take to accomplish this? Thanks a lot in advance!

Paul

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
PaulTenBrink Wed, 08/25/2010 - 03:15

OK, I will use it as a bookstand...    

Since I obviously don't know enough about networks I will stay away from 'professional' products like the Cisco products.

The user interface and the documentation of these products are clearly made by nerds for nerds...    

Thanks for your help.

Paul

Actions

This Discussion

Related Content