I have a new script that I cannot
get to and I think I nailed it down to being a issue with the trigger on the application. I set it up and compared even with another I did and when calling it I still get a system message stating "we are experiencing a problem" So somehow the trigger is not routing properly? I was playing around with it and got as far as a callmanager message stating it could not route that number so somehting is still missing? I have attached screnn shots of the trigger.
Usually, you're not going to pass a document into or out of a subflow. So just delete it from the input/output mappings on that subflow step.
Then test it, and if it works, then someone probably didn't know what they were doing and just started creating a bunch of mappings. I see this all the time.