Etherchannel Setup

Unanswered Question
Aug 15th, 2010

Has anyone seen this log message before

when attempting to configure a 2-port layer 3 EtherChannel on the same line card (WS-X6148-GE-TX), the following syslog messages were generated.

Aug 12 16:15:58.497 EST: %PM-SPSTBY-3-INTERNALERROR: Port Manager Internal Software Error (is_unallocated: ../const/native-sp/pm_sp_vlan.c: 952: pm_get_standby_vlan)

-Traceback= 40F9BDC4 40F9BFAC 40F5F490 40F9C480 40F9C4E8 40F7D614 40F7D6A8 40F7E158 40F7E3E8 40F7E814 40BDE940 40BE67CC 40ED83FC 40ED6894 40F9EFE0 40FA01AC

Aug 12 16:15:58.497 EST: SPSTBY: pm_get_standby_vlan:Cannot allocate VLAN for GigabitEthernet2/48 VLAN 1026 is use by NDE 0

Aug 12 16:15:58.497 EST: %PM-SPSTBY-4-INT_VLAN_NOTAVAIL: Failed to allocate internal VLAN in Port Manager

The etherchannel is created ok and seems fully functional, is the log entry anything to worry about.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Sun, 08/15/2010 - 18:59

Traceback can only lead to one of two things:  An IOS bug or a hardware failure.  I'm suspecting you have a cosmetic bug.

scruickshanks Sun, 08/15/2010 - 19:29

Thanks for you input

Cisco IOS Software, s3223_rp Software (s3223_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SXH5, RELEASE SOFTWARE (fc1)

Actions

This Discussion