cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
618
Views
0
Helpful
1
Replies

WAAS reboot question

svolansky
Level 1
Level 1

Hi Team,


I would like to ask you one question regarding WAAS boot procedure.


Let’s say I have physical inpath implementation on the branch WAE and need to reload it (IOS upgrade). I know that in case of HW failure the WAE will “fail to cross” acting as a cable so there is no (or little) WAN outage. But is this statement true also during reload ? Is the WAE acting as a cable when it is rebooting or the location is completely cut off and the connection is established after the reload process ?


Many thanks!


Stan

1 Reply 1

mhollowa
Level 1
Level 1

Stan,

Correct, when reloading the WAE with in-line support, the in-line card would go into pass-though mode.  Once the WAE is up, existing connections would continue in pass-though and any new connection would be optimized.

Michael

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: