08-16-2010 08:49 AM - edited 07-03-2021 07:04 PM
Hi there
we would like to configure a WLAN Workgroup Bridge with an aironet 1140 and PEAP, is this possible. Here is the actual configuration.
dot11 ssid air-secure-7
authentication open eap eap_methods
authentication network-eap eap_methods
authentication key-management wpa version 1
authentication client username xxx password 7 xxx
!
power inline negotiation prestandard source
!
!
!
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
ssid air-secure-7
!
station-role workgroup-bridge
bridge-group 1
bridge-group 1 spanning-disabled
!
Regards
Dominic
Solved! Go to Solution.
08-16-2010 09:00 AM
PEAP for WGB not supported..
http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080905cea.shtml#conf
Regards
Surendra
08-16-2010 09:00 AM
PEAP for WGB not supported..
http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080905cea.shtml#conf
Regards
Surendra
08-17-2010 12:02 AM
Hi Surendra
thanks a lot for your quick answer, this is what the Cisco Partner Helpline told me:
Thank you for contacting Worldwide Partner Helpline. My name is Marie and I will be assisting you with this case.
To answer your inquiry, yes, it is possible to configure a workgroup bridge with PEAP authentication. Kindly refer to the documentation using the link below.
PEAP under Unified Wireless Networks with ACS 4.0 and Windows 2003:
http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a00807917aa.shtml
But now I now for sure.
Regards
Dominic
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: