2801 Router

dacruzer1 · ‎08-16-2010

I have just installed a CISCO 2801 router at a remote location with two T-1 lines (see config below)

interface FastEthernet0/0
ip address 192.168.69.129 255.255.255.128
duplex auto
speed auto
!
interface FastEthernet0/1
ip address 192.168.69.1 255.255.255.128
duplex auto
speed auto
!
interface Serial0/1/0
no ip address
encapsulation frame-relay
no ip route-cache cef
frame-relay lmi-type ansi
!
interface Serial0/1/0.16 point-to-point
ip address 192.147.161.66 255.255.255.252
snmp trap link-status
frame-relay interface-dlci 16 IETF

!

interface Serial0/1/0.17 point-to-point
ip address 192.147.161.69 255.255.255.252

snmp trap link-status

frame-relay interface-dlci 16 IETF

!
router eigrp 100
network 10.0.0.0
network 192.147.161.64 0.0.0.3

network 192.147.161.68 0.0.0.3
network 192.168.69.0 0.0.0.127

network 192.168.69.128 0.0.0.127
no auto-summary
no eigrp log-neighbor-changes

Quesion: How do configure the router so that all traffic from FastEthernet0/0 will go to Serial0/1/0.16 and the traffic from FastEthernet0/1 will go to Serial0/1/0.17 ?

Thanks in advance!

Alfred

kyukim · ‎08-16-2010

Hi,

You can do it with PBR.

interface FastEthernet0/0
ip address 192.168.69.129 255.255.255.128
ip local policy route-map rm-f0-s16
!
interface FastEthernet0/1
ip address 192.168.69.1 255.255.255.128
ip policy route-map rm-f1-s17

route-map rm-f0-s16

match ip address acl-f0

set ip next-hop 192.147.161.6x --> ip address of ISP on Serial0/1/0.16

route-map rm-f0-s16

match ip address acl-f1

set ip next-hop 192.147.161.6x --> ip address of ISP on Serial0/1/0.17

ip access-list ext acl-f0

permit ip 192.168.69.0 0.0.0.127 any

ip access-list ext acl-f1

permit ip 192.168.69.128 0.0.0.127 any

Detail PBR config guide.

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a008009481d.shtml

dacruzer1 · ‎08-16-2010

Thanks much!