08-17-2010 02:06 PM - edited 03-15-2019 05:13 AM
Hello All -
We have a customer who runs a clinic where he needs a door latch system. The client will NOT have a pager at the door - the receptionist will need to physically see the patient walk to the door, then "Buzz" it open.
We can permantly designate a button for this feature if needed.
They have a 12V Electric Door Strike installed. Does anybody have a config or experience with this that they can share?
Solved! Go to Solution.
08-18-2010 02:49 AM
As indicated above: YES.
Or you can use and intercom device and simply leave the voice portion disconnected.
Please remember to rate useful posts clicking on the stars below.
08-17-2010 02:22 PM
Any device made to be connected to an FXS port will work.
In other words, any device made for any PBX will work.
08-17-2010 03:34 PM
I see you posted this on another similar Q:
http://www.sandman.com/pdf/Page40.pdf
Would this DTMF relay allow me to program a particular button on the specific phone to always open the door WITHOUT an intercom device?
08-18-2010 02:49 AM
As indicated above: YES.
Or you can use and intercom device and simply leave the voice portion disconnected.
Please remember to rate useful posts clicking on the stars below.
09-07-2010 03:16 PM
Paolo,
we got the Viking RC3:
http://assets.twacomm.com/assets/pdf/4378.pdf
What we need to know now is:
I have it to the point where the Viking RC-3 answers, but it then beeps twice and waits for the caller to enter digits to trigger one of the three relays.. I'm requesting from Cisco TAC that they provide a way for the UC540 to delay sending digits until after the Viking device answers
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: