cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
758
Views
0
Helpful
2
Replies

Voice trunk between two UC520

pbaleshenko
Level 1
Level 1

Hello.

SMB has two offices in the neighbournig buildings.

Each office has internet access and POTS line. We want to build IP-telephony in both offices and between them.

I'm going to install UC520 in each office and use it as Internet-router and IP-telephony gateway with CME.

I have the following question. I need to configure SIP/H.323 trunk between two UC520. Can I set the trunk between two UC520 if:

1) I connect them with leased line on LAN ports?

2) I connect them with IPSec tunnel?

Thanks in advance

Best regards,

   Pavel

1 Accepted Solution

Accepted Solutions

Brandon Buffin
VIP Alumni
VIP Alumni

Yes, you can use either option. You will simply create dial peers on each UC520 to handle the calls such as:

Site 1

dial-peer voice 1 voip

destination-pattern 3...

session target ipv4:1.1.1.1

dial-peer voice 2 voip

incoming called-number 4...

Site 2

dial-peer voice 1 voip

destination-pattern 4...

session target ipv4:2.2.2.2

dial-peer voice 2 voip

incoming called-number 3...

Hope this helps.

Brandon

View solution in original post

2 Replies 2

Brandon Buffin
VIP Alumni
VIP Alumni

Yes, you can use either option. You will simply create dial peers on each UC520 to handle the calls such as:

Site 1

dial-peer voice 1 voip

destination-pattern 3...

session target ipv4:1.1.1.1

dial-peer voice 2 voip

incoming called-number 4...

Site 2

dial-peer voice 1 voip

destination-pattern 4...

session target ipv4:2.2.2.2

dial-peer voice 2 voip

incoming called-number 3...

Hope this helps.

Brandon

Thanks Brandon!