ACE Module Sync Issue

Unanswered Question

Team,

We recently had an issue that the active ACE module would not sync to the standby ACE module, the following commands fixed our issue:

On the active do :
no ft auto-sync startup-config
no ft auto-sync running-config

wait about a minute and enable with:

ft auto-sync startup-config
ft auto-sync running-config

Regards,

John...

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (3 ratings)
Loading.
litrenta Wed, 08/18/2010 - 07:43

this is typical. If you get in a state where standby can't sync (say for example ssl certs and keys

or probe scripts were not copied to standby) then you correct the condition by copying the files

to standby ft will not re-initiate bulk config unless you execute those commands

. This is typical when trying to correct standby_cold condition.

cbregeripr Fri, 08/20/2010 - 12:24

Does this have any affect on connectiosn on the ACE?  I want to run this command but I can nerver drop below 4,000 connections.  I am feerful it may  drop connections. NAy feedback would be appreciated!

Chris

litrenta Tue, 08/24/2010 - 06:25

the command will not cause dropped connections. Whaqt it does is kick off config sync nothing else.

This happens all on the control plane. Load balanced connections and through ace connections are on the data plane and

are not affected.

Actions

This Discussion