Add New Nodes

Answered Question
Aug 19th, 2010
User Badges:

We have to add to our CW LMS 3.2 some WCS, WLS, ACS, FW.... but we only have HTTP or HTTPS credentials. Would that be enough to manage them? they appear as "?" and no configuration is downloaded...

Correct Answer by Joe Clarke about 6 years 8 months ago

No, this is not sufficient.  You need at least SNMP read-only access to manage these devices.  Note: Campus Manager will not support firewalls or the ACS appliance, so a '?' there is expected.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
mserranocisco Fri, 08/20/2010 - 03:06
User Badges:

SMPWalk works on some of them, but not configuration download, what else should we configure?

Joe Clarke Mon, 08/30/2010 - 11:37
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Configuration archive for the WLC and firewall devices will require either telnet or SSH access.  Configuration archive is not supported for ACS appliances or WCS hosts.

Correct Answer
Joe Clarke Mon, 08/30/2010 - 11:36
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

No, this is not sufficient.  You need at least SNMP read-only access to manage these devices.  Note: Campus Manager will not support firewalls or the ACS appliance, so a '?' there is expected.

mserranocisco Tue, 08/31/2010 - 00:38
User Badges:

Thanks!

we have problems with a WCS, we have configured ReadComunity anf HTTPS: Transport session to device failed. Cause: Authentication failed on device.

Actions

This Discussion