WiSM Controller 2 doesn't get service port IP but Controller 1 does

Unanswered Question
Aug 19th, 2010

I followed the cisco documentation for setting up the WiSM. Controller 1 is up and fine.

I see in DHCP bindings that Controller 2 is getting an IP Address and when I "session slot 9 proc 2" it tried to connect to that IP Address

but on a "show wism status" the service port of Controller 2 is

Has anyone encountered this problem?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Surendra BG Thu, 08/19/2010 - 08:41


What about the connectivity?? do we  still have the access to the WLC 2?? either from telnet or the GUI?? or  will the session to the WLC work?


bimckenz Thu, 08/19/2010 - 09:01

This is a brand new installation so I started with Controller 1 on the WiSM. I can GUI, Session ..etc into that.

I started to set up Controller B and saw the service port had but dhcp bindings show it got an IP Address. I can't session, gui...etc into Controller 2 at all.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode