Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
473
Views
0
Helpful
3
Replies

WiSM Controller 2 doesn't get service port IP but Controller 1 does

bimckenz
Level 1
Level 1

‎08-19-2010 07:15 AM - edited ‎07-03-2021 07:05 PM

I followed the cisco documentation for setting up the WiSM. Controller 1 is up and fine.

I see in DHCP bindings that Controller 2 is getting an IP Address and when I "session slot 9 proc 2" it tried to connect to that IP Address

but on a "show wism status" the service port of Controller 2 is 0.0.0.0

Has anyone encountered this problem?


Thanks

Labels:
0 Helpful
3 Replies 3

Surendra BG
Cisco Employee
Cisco Employee

‎08-19-2010 08:41 AM

Hi..

What about the connectivity?? do we  still have the access to the WLC 2?? either from telnet or the GUI?? or  will the session to the WLC work?

Regards
Surendra

Regards
Surendra BG
0 Helpful

bimckenz
Level 1
Level 1
In response to Surendra BG

‎08-19-2010 09:01 AM

This is a brand new installation so I started with Controller 1 on the WiSM. I can GUI, Session ..etc into that.

I started to set up Controller B and saw the service port had 0.0.0.0 but dhcp bindings show it got an IP Address. I can't session, gui...etc into Controller 2 at all.

0 Helpful

bimckenz
Level 1
Level 1
In response to bimckenz

‎08-19-2010 09:08 AM

attached is the show ip dhcp binding and the show wism status

70747-putty.log.zip
0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card