BladeCenter and CDP

Unanswered Question
Aug 19th, 2010

I currently have 2 - CIGESMs in a bladecenter.  When I run the command show cdp neighbor with the Advanced Mgmt Module installed it shows no neighbors.  When I do the same with an older Mgmt Module it works fine.  ( I am able to see an upstream switch that is connected to the Cigesm with show cdp neighbor with both the MM and AMM ) 

Does anyone know if anything needs to be configured differently on the Cigesm to get CDP to work with the AMM ?

Thanks in advance.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion