08-19-2010 09:38 AM - edited 03-16-2019 12:21 AM
I have and issue that the outbound calling info is incorrect from the 2811 CME box. We currently have a PRI terminated into this box and would like to change the number being sent/displayed on outbound calls to external cell phones/devices. Any idea how I do this?
Solved! Go to Solution.
08-19-2010 10:52 AM
If you want to have the same number for all outgoing calls then you can add "isdn calling-number xxx-xxx-xxxx" to your serial interface as shown below. If you want everyone's DID to go out as there own number then you will need to create translation's on your gateway to do acheive this.
interface Serial6/0:23
no ip address
no logging event link-status
isdn switch-type primary-ni
isdn incoming-voice voice
isdn calling-number xxx-xxx-xxxx
no cdp enable
HTH, Please rate if so.
Regards,
Justin
08-19-2010 11:27 AM
If using translation rules to mask everyone to the same number:
!
voice translation-rule 1
rule 1 /.*/ /3305551212/
!
!
voice translation-profile CALLERID
translate calling 1
!
!
dial-peer voice 10 pots
translation-profile outgoing CALLERID
destination-pattern 81[2-9].........
port 1/0/0:23
forward-digits 11
!
08-19-2010 10:52 AM
If you want to have the same number for all outgoing calls then you can add "isdn calling-number xxx-xxx-xxxx" to your serial interface as shown below. If you want everyone's DID to go out as there own number then you will need to create translation's on your gateway to do acheive this.
interface Serial6/0:23
no ip address
no logging event link-status
isdn switch-type primary-ni
isdn incoming-voice voice
isdn calling-number xxx-xxx-xxxx
no cdp enable
HTH, Please rate if so.
Regards,
Justin
08-19-2010 11:27 AM
If using translation rules to mask everyone to the same number:
!
voice translation-rule 1
rule 1 /.*/ /3305551212/
!
!
voice translation-profile CALLERID
translate calling 1
!
!
dial-peer voice 10 pots
translation-profile outgoing CALLERID
destination-pattern 81[2-9].........
port 1/0/0:23
forward-digits 11
!
08-19-2010 12:40 PM
Thank you. This worked perfectly.
08-19-2010 11:41 AM
How the current number is incorrect, and what number you want to display instead ?
08-19-2010 12:41 PM
Thank you. The above suggestions worked for me.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: