Not been on here for a long time, and I've got a bit of a sticky problem with some new kit I'm going to be using for a remote access services.
Now we are going to be using the good old ipsec vpn client for a while yet and everything works swimmingly with that.
But we're also going to use W7 soon and that means switching to the Anyconnect client.
We have several tunnel and user groups which have different rules for connecting.
Three of the groups have specific ip address pools for security reasons.
Everyone else just relies on dhcp from the inside network subnet.
These work a treat with our old friend the ipsec client.
However I've configured the Anyconnect client with specific profiles so they only connect to their specified goups..... but it doesn't want to work.
Everytime you connect you end up in the DefaultWEBVPNGroup and we get addressing from the dhcp subnet instead of the pool setup for the group-xxxx which the anyconnect profile spcifies.
I've tried all sorts, but coming up blank, it's the most annoying problem with these boxes.
Anyone got any ideas?