Cisco Meeting Place 1-800 number

latintrpt · ‎08-20-2010

Hello,

I've been asked to set a 1-800 number so that outside user's can dail into our access number for Meeting Place through this 1-800 number. I've ordered a 1-800 number through ATT but they are asking me if I can confirm a telephone number that I would like it to be pointed to. I'm not sure to where it should be pointed to though.

Any Ideas?

Thanks

Steven Holl · ‎08-20-2010

Sounds like you need to map it to a DID which you already own that is coming in a circuit connected to the CM which will be hosting MP. Then you configure call to that unique DID to route to MP.