OSPF and RIP??

Unanswered Question
Aug 20th, 2010
User Badges:

Hi,



I want to communicate between these network where are use OSPF with different Area -> RIP -> OSPF, without using GRE, Redistribution, virtual link, PBR, other routing protocol, ipv6 so we can use only one static or default route so How I can?



All ospf have Loopback with RID.



Please help us..

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
abhi-adte Sat, 08/21/2010 - 04:44
User Badges:

if any know how we can do it...???


without using GRE, Redistribution, virtual link, PBR, other routing protocol, ipv6 and how we can make connectivity.

Lei Tian Sat, 08/21/2010 - 05:53
User Badges:
  • Cisco Employee,

Hi Abhinay,


I guess that's for lab testing only, correct? What's the topology look like? How many static routes can we use?


HTH,

Lei Tian

Lei Tian Tue, 08/24/2010 - 03:50
User Badges:
  • Cisco Employee,

Hi Abhinay,


I am sure there are other solutions, here is my thought.


on R5
default-information originate alway to ospf
ip summary-address rip 56.56.56.0/24 on fa0/0


on R4
default-information originate always to ospf
ip summary-address rip 0.0.0.0/0 on fa0/1


HTH,
Lei Tian

abhi-adte Wed, 08/25/2010 - 06:18
User Badges:

its not done , because we all configure on rip interface can

u please provide the config...


please help us    

Lei Tian Wed, 08/25/2010 - 10:55
User Badges:
  • Cisco Employee,

Hi Abhinay,


Here is the configuration I was talking about.
on R5
router ospf x

default-information originate alway
int fa0/0
ip summary-address rip 56.56.56.0 255.255.255.0
on R4
router ospf X

default-information originate always
int fa0/0

ip summary-address rip 0.0.0.0 0.0.0.0


Are you saying you can only make configuration changes on RIP?
HTH,
Lei Tian

Actions

This Discussion