08-20-2010 07:00 AM - edited 03-06-2019 12:34 PM
Hi,
I want to communicate between these network where are use OSPF with different Area -> RIP -> OSPF, without using GRE, Redistribution, virtual link, PBR, other routing protocol, ipv6 so we can use only one static or default route so How I can?
All ospf have Loopback with RID.
Please help us..
08-21-2010 04:44 AM
if any know how we can do it...???
without using GRE, Redistribution, virtual link, PBR, other routing protocol, ipv6 and how we can make connectivity.
08-21-2010 05:53 AM
Hi Abhinay,
I guess that's for lab testing only, correct? What's the topology look like? How many static routes can we use?
HTH,
Lei Tian
08-23-2010 11:20 PM
08-24-2010 03:50 AM
Hi Abhinay,
I am sure there are other solutions, here is my thought.
on R5
default-information originate alway to ospf
ip summary-address rip 56.56.56.0/24 on fa0/0
on R4
default-information originate always to ospf
ip summary-address rip 0.0.0.0/0 on fa0/1
HTH,
Lei Tian
08-25-2010 06:18 AM
its not done , because we all configure on rip interface can
u please provide the config...
please help us
08-25-2010 10:55 AM
Hi Abhinay,
Here is the configuration I was talking about.
on R5
router ospf x
default-information originate alway
int fa0/0
ip summary-address rip 56.56.56.0 255.255.255.0
on R4
router ospf X
default-information originate always
int fa0/0
ip summary-address rip 0.0.0.0 0.0.0.0
Are you saying you can only make configuration changes on RIP?
HTH,
Lei Tian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide