Remote Access to Secure Series 500 router

Answered Question
Aug 20th, 2010
User Badges:

Hi all, I know this question is probably asked all the time but I am wanting to allow remote access through ssh and possibly telnet from WAN on a secure series 500 router.  I've configured the firewall settings with the Cisco Configuration Assistant mostly.  Is there any step-by-step way that normally works for allowing these connections and if so could you give me a step-by-step example.  I greatly appreciate it.

Correct Answer by Federico Coto F... about 6 years 11 months ago

Hi,


Normally you would not want to allow telnet on the WAN side (unless is your only option).

To configure SSH, you need an IOS image that supports encryption ''shows k8/k9 on the image name''


Normally to configure SSH, you do the following:

Configure hostname

Configure domain-name

Generate RSA keys

Enable AAA with a local user

Authenticate SSH agains the local database


Federico.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Federico Coto F... Thu, 08/26/2010 - 18:03
User Badges:
  • Green, 3000 points or more

Hi,


Normally you would not want to allow telnet on the WAN side (unless is your only option).

To configure SSH, you need an IOS image that supports encryption ''shows k8/k9 on the image name''


Normally to configure SSH, you do the following:

Configure hostname

Configure domain-name

Generate RSA keys

Enable AAA with a local user

Authenticate SSH agains the local database


Federico.

Joseph E Spoon Thu, 09/12/2013 - 21:48
User Badges:

This worked thank you for your response.  Going through past discussions.


Thanks

Actions

This Discussion