Intel Pro 100 & Cisco Catalyst 2960G

Unanswered Question

Hello, I have this issue:

Switch Cisco Catalyst 2960G + utp cat 6 cable + nic Intel Pro 100 VM (With WIN XP latest drivers)

I can't get it work.

Autosensing in both points = cable disconected

100 full in both points = connection ok, but no pings

100 half in both pints = connection ok, but no pings

10 full or half in both points = lose many pings (50% of them)

This problem happens only with this type of nic (tested three different ones). If I change the nic (intel pro 1000, 3com, or realteck, or Broadcom) the connection is ok at any speed (10 / 100 / 1000).

Is there any know bug or problem related with this nic?

NOTE: unchecking "allow the computer turn off this device" doesn't work.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion