ata 186 14400

Unanswered Question
Aug 23rd, 2010

Anyone able to get an ATA to run at 14400?

thx as always

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Aaron Harrison Tue, 08/24/2010 - 00:19


General tips:

1) Disable ECM and any high-speed/fancy features you can on the fax front panel itself

2) Ensure your E1s have no clock slips using 'sh controllers e1'

3) Ensure you have a 100% QoS setup with as little packet loss as possible

4) Be happy if your faxes work.. the above tend to improve reliability but slower speeds are typical on ATAs in my experience.



Please rate helpful posts...

Steven Holl Tue, 08/24/2010 - 06:54

Can you explain your topology in more detail?  What protocol are you running on the ATA?  What VoIP protocol is your PSTN gateway running?  And What is the PSTN connection?  Is the PSTN connection an IP SIP trunk?


This Discussion