08-23-2010 05:28 PM - edited 03-16-2019 12:26 AM
Anyone able to get an ATA to run at 14400?
thx as always
08-24-2010 12:19 AM
Hi
General tips:
1) Disable ECM and any high-speed/fancy features you can on the fax front panel itself
2) Ensure your E1s have no clock slips using 'sh controllers e1'
3) Ensure you have a 100% QoS setup with as little packet loss as possible
4) Be happy if your faxes work.. the above tend to improve reliability but slower speeds are typical on ATAs in my experience.
Regards
Aaron
Please rate helpful posts...
08-24-2010 06:54 AM
Can you explain your topology in more detail? What protocol are you running on the ATA? What VoIP protocol is your PSTN gateway running? And What is the PSTN connection? Is the PSTN connection an IP SIP trunk?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide