08-23-2010 07:42 PM - edited 02-21-2020 04:03 AM
Hi.
Help me please to undestand.
I have OOB mode on next equipment:
CAM 4.7.2
CAS 4.7.2
2811 router
win2008r2 enterprise
Linksys srw2008mp
Catalist 4000
same hosts: winxp and win7 with nacagent 4.7.2
AD SSO on CAM started, ports on switch is controled.
On layer 3 network works fine, but nacagent on hosts don't started.
Solved! Go to Solution.
09-05-2010 05:30 AM
In your network.png screen capture you do not have "Enable L3 support" checked. You need this checked if the computer is one or more L3 hop away from the NAC server. Since you're running in OOB Real IP GW mode, I'm assuming this is the case. You'll just have to run through these steps
1. check the box
2. reboot the NAC server
3. try again
Could you provide a diagram of your scenario? That would help out a lot.
Rob
08-25-2010 03:38 AM
Alexandr,
Please post screen shots of your CAS configuration pages (Network, Managed subnets, VLAN mappings if VGW, Static routes if RIP) and the Traffic policies page.
Faisal
08-31-2010 03:52 AM
09-05-2010 05:30 AM
In your network.png screen capture you do not have "Enable L3 support" checked. You need this checked if the computer is one or more L3 hop away from the NAC server. Since you're running in OOB Real IP GW mode, I'm assuming this is the case. You'll just have to run through these steps
1. check the box
2. reboot the NAC server
3. try again
Could you provide a diagram of your scenario? That would help out a lot.
Rob
10-05-2010 08:17 PM
it's work.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide