08-24-2010 09:02 PM - edited 03-06-2019 12:38 PM
Hi I am not sure if this is the right place to ask this question about QoS.
I want to know if ther is a way to check if the specific traffic has been identified as class EF by auto QoS. how can I verify if the auto Qos has correctly tagged my traffic as "EF". If there is how can i do this on my routers and switches?
Thanks!
08-25-2010 02:03 AM
You could mirror one of the ports and capture the traffic.
the information should be visible in the capture.
The other option is to install a netflow capture box.
Most flavors of this (Solarwinds, crannog, Whatsup gold) can give good information when configured properly.
08-25-2010 06:47 PM
Hi,
how about for the cli commands? is there a debug or show command to show this?
08-26-2010 05:02 AM
ejlbarcelon wrote:
Hi,
how about for the cli commands? is there a debug or show command to show this?
I don't tend to use the CLI except to check the config is right, mappings etc.
i will have a look though.
try here:
http://docwiki.cisco.com/wiki/Cisco_IOS_Voice_Troubleshooting_and_Monitoring_Guide
and
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: