Dialable intercom not working yet

Unanswered Question
Aug 25th, 2010
User Badges:
  • Bronze, 100 points or more

Hello,


It sends *DB out my Sip trunk so I'm getting a busy signal immediatly. What can I do to keep it inside? Also, it was trying to register the dn's with my service provider, so I manually cleaned that up. I'm very excited for this feature to work with CCA, but I think I need a tweak yet.


Thanks

Stephanie

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
antyeung Thu, 08/26/2010 - 20:37
User Badges:
  • Bronze, 100 points or more

Hm... doesn't sound right that it would send *DB to your SIP provider.


Can you provide your 'show run' excluding the pwds and enable the following debugs when you try to use dialable intercom?


Thanks,

Anthony

SHeidemann Fri, 08/27/2010 - 14:11
User Badges:
  • Bronze, 100 points or more

I tried to send this over as well

antyeung Fri, 08/27/2010 - 14:36
User Badges:
  • Bronze, 100 points or more

We found the problem and we are actively working on resolving this. As a workaround you would need to go into the CLI and shutdown one of your dial-peers.


Can you post your 'show run' output excluding the pwds? I'll be able to tell you which dial peers to shutdown.


Thanks,

Anthony

antyeung Fri, 08/27/2010 - 14:40
User Badges:
  • Bronze, 100 points or more

Does your SIP trunk provider support star codes? If not you'll need to shut down these dial peers for dialable intercom to work in the interim-


dial-peer voice 1001

shut


dial-peer voice 1002

shut


Thanks,

Anthony

SHeidemann Fri, 08/27/2010 - 14:51
User Badges:
  • Bronze, 100 points or more

Seems to have done the trick. Thank you for the help. I'm not positive if my provider supports star codes, but most likely not.



Again

Thanks!

antyeung Sun, 08/29/2010 - 17:05
User Badges:
  • Bronze, 100 points or more

NP. Good to hear you're all set.


-Anthony

Actions

This Discussion