cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
818
Views
0
Helpful
2
Replies

SRST in H.323

mathyalagan.v
Level 1
Level 1

I need some clarification regarding SRST in H.323 gateway.

Usually, reset command in call-manager-fallback will helps to register the phones back to CCM in MGCP gateway. What about H.323.

How to bring the phones back to the CCM in the H.323 gateway. If the phones are not trying to register with CCM even the CCM is up and active.

2 Replies 2

William Bell
VIP Alumni
VIP Alumni

The reset command should still apply. The SRST portion of a gateway is a

separate function from the mgcp failover to default/h323. Further, the SRST

function in a H.323 gateway is essentially the same as on a MGCP. IOW, the

client side of the SRST behavior we all know and love is separate from the

trunk side.

HTH.

Regards,

Bill

On 8/25/10 8:27 PM, "mathyalagan.v"

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Steven Holl
Cisco Employee
Cisco Employee

The phones should be trying to hone back to CM when in a SRST failover situtation every 2 minutes by default.  There is an enterprise parameter associated with this.

This parameter specifies the a common link qualifying time period for all the devices using a specific SRST reference.
This is a required field.
Default:                  120
Minimum:                  0
Maximum:                  2592000

This may sound weird, but hitting the hookflash switch on the phone a couple times usually seems to trigger a switchback, if it is 'stuck'.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: