Dial Backup method to use on an 1811 ISR

Unanswered Question
Aug 26th, 2010

I am confused as to the methods available to implement Dial Backup on an 1811 ISR.

My router's WAN is connected to a cable modem via FA0.

In reading the 1811 software configuration guide (chapter 13, page 13-5), I have viewed a table listing "Dial Backup Feature Limitations".

I do not know how to interpret this table.

Is it telling me that Dial Backup on an 1811 is not possible using my "Normal IP cable modem senario"?

Any insight into this issue is gratefully appreciated.

regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
Loading.
Paolo Bevilacqua Thu, 08/26/2010 - 11:57

Before delving into technicalities.

Where would you dial backup to ?

Do you have the needed experience or certification to configure Cisco routers ?

rnlaberge Thu, 08/26/2010 - 12:06

Sorry to have intruded into the club.

I will seek assistance elsewhere.

Paolo Bevilacqua Thu, 08/26/2010 - 13:11

It would have been enough to say, I'm a beginner.

Good luck, with this attitude you will need some.

Actions

This Discussion