Unable to load IPS 4240 IOS from Rom Mode

arekemase · ‎08-27-2010

Hi Experts,

Kindl asist me in load the IPS IOS on the IPS 4240 from rommon mode.

Note: I can only access the IPS via rommon only becuase the existing ios is cuppted and formatted.

The rommon output is give bellow:

rommon #2> set
ROMMON Variable Settings:
ADDRESS=192.168.2.16
SERVER=192.168.2.58
GATEWAY=192.168.2.1
PORT=Management0/0
VLAN=untagged
IMAGE=C:\IOS\Tftpd32\IPS-4240-k9-sys-1.1-a-6.1-1-E2.img
CONFIG=
LINKTIMEOUT=20
PKTTIMEOUT=4
RETRY=20

rommon #14> ping 192.168.2.16
Sending 20, 100-byte ICMP Echoes to 192.168.2.16, timeout is 4 seconds:
?
Success rate is 0 percent (0/20)
rommon #15> ping 192.168.2.58
Sending 20, 100-byte ICMP Echoes to 192.168.2.58, timeout is 4 seconds:
?!!!!!!!!!!!!!!!!!!!
Success rate is 95 percent (19/20)
rommon #0> ping 192.168.2.1
Sending 20, 100-byte ICMP Echoes to 192.168.2.1, timeout is 4 seconds:
!!!!!!!!!!!!!!!!!!!!
Success rate is 100 percent (20/20)
rommon #1> ping 192.168.2.16
Sending 20, 100-byte ICMP Echoes to 192.168.2.16, timeout is 4 seconds:
??????????????
Success rate is 0 percent (0/20)
rommon #2>

The major problem is that i cannot ping the ips interface address 192.168.2.16) while i can ping all the others.

Thanks in anticipation!

Regards

Allen P Chen · ‎08-27-2010

Hello,

It is OK for the sensor to not be able to ping its own interface in ROMMON mode. Based on the output, it looks like the sensor is able to ping the server at 192.168.2.58. Are you having issues with the TFTP process? What happens when you issue the "tftp" command?

arekemase · ‎08-31-2010

Hi Allen,

Here is the output when i issue tftp command at rommom mode:

TFTP failure: Rx TFTP Error Packet
TFTP OP Code: Error Packet
Error Msg: File not found

Thanks In anticipation for your responds Allen!

pevaneyn · ‎08-31-2010

Hi,

From the error message the file was not found on the tftp server.

I see that you have:

IMAGE=C:\IOS\Tftpd32\IPS-4240-k9-sys-1.1-a-6.1-1-E2.img

I am guessing that this should be:

IMAGE=IPS-4240-k9-sys-1.1-a-6.1-1-E2.img

as the tftp daemon on your machine probably is using C:\IOS\Tftpd32\ as the 'root' directory of the files it is serving.

You can check this in the settings of the tftp daemon.

Best regards, Peter

arekemase · ‎09-01-2010

Hi,

The root directory for the ios on my TFTP Server is :C:\IOS\Tftpd32\

Best Regards

pevaneyn · ‎09-01-2010

Hello again,

Ok, so does 'IMAGE=IPS-4240-k9-sys-1.1-a-6.1-1-E2.img' work?

If not what messages do you get?

Best regards, Peter

surasubr · ‎05-01-2018

Wow this solved my issue. Thank you.

arekemase · ‎09-01-2010

Thanks man,

Its Working. I really appreciate alot.

Best Regards