We are using WS-C3750G-12S-S now we need to PBR in this switch.
Current IOS : flash:c3750-i9-mz.122-20.SE3/c3750-i9-mz.122-20.SE3.bin
I am not sure , it is support PBR of this switch or not
Cisco Internetwork Operating System Software
IOS (tm) C3750 Software (C3750-I9-M), Version 12.2(20)SE3, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Sun 17-Oct-04 01:18 by antonino
Image text-base: 0x00003000, data-base: 0x00997458
ROM: Bootstrap program is C3750 boot loader
BOOTLDR: C3750 Boot Loader (C3750-HBOOT-M) Version 12.1(19r)EA1b, RELEASE SOFTWARE (fc2)
switch-3750-1 uptime is 2 weeks, 5 days, 13 hours, 5 minutes
System returned to ROM by power-on
System image file is "flash:c3750-i9-mz.122-20.SE3/c3750-i9-mz.122-20.SE3.bin"
cisco WS-C3750G-12S (PowerPC405) processor (revision H0) with 118784K/12280K bytes of memory.
Processor board ID CAT0841Y022
Last reset from power-on
7 Virtual Ethernet/IEEE 802.3 interface(s)
12 Gigabit Ethernet/IEEE 802.3 interface(s)
The password-recovery mechanism is enabled.
512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:12:43:7E:74:80
Motherboard assembly number : 73-8307-08
Power supply part number : 341-0048-01
Motherboard serial number : CAT084103ZB
Power supply serial number : DTH08361BED
Model revision number : H0
Motherboard revision number : A0
Model number : WS-C3750G-12S-S
System serial number : CAT0841Y022
Top Assembly Part Number : 800-21966-01
Top Assembly Revision Number : K0
Version ID : N/A
Hardware Board Revision Number : 0x07
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 12 WS-C3750G-12S 12.2(20)SE3 C3750-I9-M
Configuration register is 0xF
Please helpe me it's very URGENT.
Thansk in ADV,
Legally you need to purchase SMI to EMI license for upgrade, but the switch itself cannot prevent you just upgrade the code without buying the license. For my customer I will recommend them buy the license or contact the sales;for my lab I will just upgrade the code. I hope you understand I am not suppose to tell you do anything against the policy at here, so my answer to your question is you need to buy license for upgrade.
No, it doesnt.
•To use PBR, you must have the IP services image installed on the stack master.
•To use PBR, you must first enable the routing template by using the sdm prefer routing global configuration command. PBR is not supported with the VLAN or default template.