Flow between VPN Client and Site-to-Site VPN

Answered Question

Looking for an ASA 8.0 sample configuration for enabling traffic flow between a Cisco VPN remote access client and destination host connected via LAN/Site-to-Site tunnel.  Both remote access client and site-to-site tunnel terminate on the same ASA device.


Thanks in advance.


-Rey

Correct Answer by praprama about 6 years 7 months ago

Hello Rey,


Here is a config example for what you are looking for.


http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f307.shtml


Hope this helps.


P.S: This uses TACACS+ for authentication which you can substitute with your method of authentication.


Regards,

Prapanch

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Nagaraja Thanthry Sat, 08/28/2010 - 20:10
User Badges:
  • Cisco Employee,

Hello,


As long as both VPN sessions are working, you can try the configuration below:


access-list nonat permit ip

access-list nonat permit ip

access-list nonat permit ip

access-list nonat permit ip


nat (inside) 0 access-list nonat


http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00804675ac.shtml


Hope this helps.


Regards,


NT


Message was edited by: Nagaraja Thanthry

Actions

This Discussion