Solved: Flow between VPN Client and Site-to-Site VPN

98510 · ‎08-28-2010

Looking for an ASA 8.0 sample configuration for enabling traffic flow between a Cisco VPN remote access client and destination host connected via LAN/Site-to-Site tunnel. Both remote access client and site-to-site tunnel terminate on the same ASA device.

Thanks in advance.

-Rey

praprama · ‎08-28-2010

Hello Rey,

Here is a config example for what you are looking for.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f307.shtml

Hope this helps.

P.S: This uses TACACS+ for authentication which you can substitute with your method of authentication.

Regards,

Prapanch

View solution in original post

Nagaraja Thanthry · ‎08-28-2010

Hello,

As long as both VPN sessions are working, you can try the configuration below:

access-list nonat permit ip

nat (inside) 0 access-list nonat

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00804675ac.shtml

Hope this helps.

Regards,

NT

Message was edited by: Nagaraja Thanthry

98510 · ‎08-31-2010

Thanks!

praprama · ‎08-28-2010

Hello Rey,

Here is a config example for what you are looking for.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f307.shtml

Hope this helps.

P.S: This uses TACACS+ for authentication which you can substitute with your method of authentication.

Regards,

Prapanch

98510 · ‎08-31-2010

Thanks! This is my answer!