08-29-2010 11:27 AM - edited 03-06-2019 12:42 PM
Hi2All
I am wondering if two SFP ports on my Cisco 2960 can be combined as one pipe connection to my backbone switch 4506
This is redundancy and additional 1GB pipe, in total my backbone connection from this switch would be 2GB
cheers
Anthony
08-29-2010 11:42 AM
Hello,
You can certainly do that. You need to configure EtherChannel between the
devices.
http://www.cisco.com/en/US/tech/tk389/tk213/technologies_tech_note09186a0080
094646.shtml#topic6
http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/1
2.2_25_see/configuration/guide/swethchl.html
Hope this helps.
Regards,
NT
08-29-2010 12:16 PM
Hi2All,
Thanks for answering.
Are these config ok for etherchannel
On 2960 Switch & Backbone_switch 4506 I configure these.
interface range giga 0/1 - 2
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode active
Any precautions do I need for Ethernchannel during configuration.
cheers
Anthony
08-29-2010 12:18 PM
Hello,
That configuration looks good. As long as both links are active, you should
not have any problem.
Regards,
NT
08-29-2010 12:37 PM
Hi2All,
which command would help to understand the current bandwidth usuage of uplink on BackBone_Switch and how do I check the same from Cisco 2960 switch.
Just a thought :::::: Can i do etherchannel with ethernet giga0/1 + sfp giga 0/1 on cisco 2960 with backbone 4509 two giga ethernet interface
cheers
Anthony
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide