Establish communications between data center using single connections to each layer 2 device

Unanswered Question
Aug 30th, 2010

Were in the process of developing a network between two data center using Cisco Nexus 5k with the overall concept of having an active-active process during normal business hours. Thus far, I have been able to communicate between sites using a 1:1 ratio Nexus1 can communicate with Nexus1 using the same fiber circuit however I'm unable to communicate from Nexus1 to Nexus 2. I have attempt to use port channeling with unique names placing all the required vlan on this channel group however I was unable to see that device as a neighbor. Any suggestions?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion