Installing a Netflow Service Card for a Supervisor V

Unanswered Question
Aug 31st, 2010
User Badges:

Is there any installation procedure to install a Netflow Service Card (WS-F4531=) on a Supervisor V (WS-X4516)?

I can only find a procedure to do it for a Supervisor IV, but i am not sure if this procedure is valid for a Supervisor V.


Regards


Pedro

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
kyukim Tue, 08/31/2010 - 18:48
User Badges:
  • Cisco Employee,

Hi,


There should be no difference between SUP IV and SUP V for installation procedure.


Hardware and Software Requirements

To install and use the NetFlow Services Card, you need the following:

Catalyst 4500 series switch (Catalyst 4503, 4506, 4507R, or Catalyst 4006)

Supervisor Engine IV or Supervisor Engine V running Cisco IOS Version 12.1(13)EW or greater


http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/hardware/configuration/notes/78-15214.html#wp59422


IOS CONFIG GUIDE

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/20ew/configuration/guide/nfswitch.html


KK.

Actions

This Discussion