09-01-2010 07:39 AM - edited 03-21-2019 02:57 AM
Dears,
Please advice what is the correct process to shut down the UC520.
Thanks & Regrds,
Mohammed
09-01-2010 07:50 AM
here is what I do...
Save the running configuration using CCA or CLI 'write memory' so the running config gets written to the startup-config used next time its plugged in.
Unplug the LAN ports and expansion port cables to make sure there is nothing reading or writing to Flash memory.
Unplug it.
09-01-2010 08:00 AM
Thank you Steven,
Sorry if the question is not clear, I mean how to correctly shutdown the UC520 to prevent CUE damage.
Thanks in advance.
Regards,
Mohammed
09-01-2010 08:02 AM
Removing the power is the shutdown. There are no spinning disks.
09-01-2010 08:38 AM
OK, thank you Steven for your fast respone.
And It's clear now.
Best Regards.
Mohammed
09-02-2010 07:30 AM
I would shut the CUE module down before pulling the plug. You don't want to pull the plug on a *nix environment, regardless of if there
is a spinning disk or not. CUE could be writing to the database at the time you pull the plug, and you may corrupt something there.
!Saves config
CME# se i0/0 sess
CUE# wr
Ctrl + Shift + 6 then hit 'x' to drop back to the router prompt after this.
CME# se i0/0 shutdown
(Hit Enter twice if you want to watch the module's shutdown messages.)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: