Can't define PVE Uplink with srw224g4

Unanswered Question
Sep 1st, 2010


I tried to  setup sample usage of PVE with Linksys  SRW224G4 withot success. I successfully set PVE g1 for ports 1 to 5 but I can't setup uplink port for this PVE group. I can't find place where can define PVE mapping an PVE upllink in web view. When I googled about this  I find that in "Port config" section in firmware version befor 1.2.2 have "pve mapping", but there is not such link. How can i define Uplink for particular PVE group in firmware version before 1.2.2?

Thanks in advance

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion