Problem with inline module on WAE device "Disable bypass mode is on"

Unanswered Question
Sep 2nd, 2010
User Badges:

Hi all,


I have run into a problem with a new WAE 674 appliance with integrated inline adapter.

I did a basic setup and everything seemed to work properly until we tested the

mechanical bypass of the inline card ( power failure). Unfortunately this feature does

not work on this new WAE/inline card. I compared the configuration with some other,

already installed WAEs, and did not find any misconfiguration. I have found one

difference, though - when i do a "show interface inlinegroup 1/0" a get a line which

is:  "Disable bypass mode is on".

On all other WAEs with inline interfaces we have this line is: "Disable bypass mode is off"


Does this mean that mechanical bypass is administratively turned off ? And if so, how can this

turned on again ?


Thank you for your kind help


With kind regards


Andreas

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion