09-02-2010 08:07 AM - edited 03-16-2019 12:35 AM
Hi,
The requirement is to integrate CUCM 4.2 with Polycom RMX, audio conference bridge, and CMA, management platform. Also, Polycom CMA can provide Gatekeeper functionality. I read in a forum that this can be done with H.323 Gatekeepers. Is it possible to register a CUCM 4.2 to Polycom Gatekeeper on CMA? Please provide configuration example.
Thanks,
Nelson
Solved! Go to Solution.
02-21-2011 06:46 AM
02-21-2011 06:46 AM
12-12-2011 01:02 PM
nsheridan/everyone,
I have followed the that document but was not successful. Is it possible to SIP trunk between an RMX2000 and CUCM without the use any gatekeeper?
Is it possible to route calls from the CUCM to the RMX without using CMA, Call manager Express, or DMA? Only CUCM 8.x and RMX2000.
Best regards,
AA
12-13-2011 12:09 AM
Ahmed,
We have a number of route patterns which provide direct dials for IP phones w/ video advantage (or any other device registered with CUCM) to Polycom endpoints. This is to allow video advantage to dial polycom endpoints without a gatekeeper
In practice:
IMHO a route list via an H323 trunk to the CMA (the way I have done it and the way I understand the document describes) is the most superior way, as it allows for a range of numbers to be listed as a route pattern - similar to a summary IP route. Infact the technology prefix used by CUCM when it registers should be sufficient to "steer the calls" in the right direction when going from polycom to CUCM. I would consider both directions.
Sadly - in my experience only - if you are planning on using video advantage, brace yourself to be a little dissappointed. The flexibility (or lack of) of the aspect ratio, and the quality might not impress - or work at all, but at least you'll get audio oevr IP. I am keeping my fingers crossed for a tanberg product to make video advantage obsolete, and to provide features like (for example) CMA desktop. Maybe there already is a product that achieves this?
hope it helps
12-14-2011 06:12 AM
nsheridan,
Thank you, it has helped immensely.
I do not know of any tanberg product to make video advantage obsolete.
-AA
05-11-2014 06:38 PM
Configure it as an ICT Trunk pointing to RMX2000, it will works great! :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide