Cisco WLC 2125 and AIR-LAP1252AG-A-K9 access points

Unanswered Question
Sep 2nd, 2010
User Badges:

We are running into a little issue here and looking for some help. We have the Controller configured and it appears to be working properly the issue we are running into is that we can only get the above mentioned access points to only join the controller if they are plugged directly into the controller. I would assume that we should be able to plug these access points into any of our switches and they should be able to join the controller correct? Obviously there has to be a configuration issue somewhere and am hoping someone can point us in the right direction.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Thu, 09/02/2010 - 16:12
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

WAP to Switch - Access port

WLC to Switch - dot1Q trunk on the switch and tagged on the WLC side


This Discussion