Cisco SLM 2008, automatically change port setting (enable/disable)

Unanswered Question
Sep 6th, 2010

Is there a way to automatically change the port state (SLM 2008 switch) from enabled/100MB/1000MB  to the disabled state?

The setting change must occur on certain times of the day.

Or, if possible, based on port statistics (number of Mbytes sent/received).

For example by running a script on the switch itself,  or on a device connected to the switch (PC)?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joachim Kern Mon, 09/06/2010 - 08:17

on a PC

you might want to look into an SNMP management system which can be scripted

or use Radius authentication to de-authorize the port at specific times

Joachim Kern Tue, 09/07/2010 - 07:09

sorry, no SNMP

my fault

you need to invest into a fully managed switch, seems the SLM series is too leightweight for that


This Discussion

Related Content