cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1055
Views
0
Helpful
2
Replies

SPA 504G Not showing up in the

zuhalter69
Level 1
Level 1

We have 4 SPA 504Gs on our network of 1qty SPA9000 / 1qty SPA400 and they are not showing up when when we do the Auto Config with the Wizard. We also have WIP310 that show up just fine. I have the SPA 504G working but had to configure them manually. I would just like to know why they are not showing up in the Configuration Wizard.

1 Accepted Solution

Accepted Solutions

klogata
Level 1
Level 1

Hi,

Are the phones running the latest firmware? (7.4.6) Also do you have the latest Wizard version (beta)? See:

https://supportforums.cisco.com/docs/DOC-9876

Also, see this older post:

https://supportforums.cisco.com/docs/DOC-9882

View solution in original post

2 Replies 2

klogata
Level 1
Level 1

Hi,

Are the phones running the latest firmware? (7.4.6) Also do you have the latest Wizard version (beta)? See:

https://supportforums.cisco.com/docs/DOC-9876

Also, see this older post:

https://supportforums.cisco.com/docs/DOC-9882

Yeah, thanks for the Beta Link that is all that was required.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: